DIY Floating Flower Table Display
Looking for a beautiful and easy way to display flowers at your next party or event? Look no further than this DIY Floating Flower Table Display!
Cost: $20
Equipment
- Wire cutter
- Drill with 1/16″ drill bit
- Bolt cutters
Instructions
- Drill a hole into each of the blocks.
- Once the holes are drilled, cut the brass rods with bolt cutters. You can cut varying heights to add interest to the final setup.
- Add a small pinch of sticky putty to the bottom of the blocks where you drilled a hole. Then, flatten out the putty by pushing the blocks down onto the surface. The putty will hold the brass rods and flower in place.
- Stick each brass rod into each acrylic blocks.
- Snip a flower bloom and slide the stem down over the end of the rod.